Slappy mini ramp3/31/2023 ![]() ![]() The bolt at the bottom of the illustration on the right is also known as a clothesline hook and is the most common for this application. Tighten the bolts down secure to the 2x4 using nuts and washers. Remove the coping and drill the 3/8" holes where you have just indicated.įeed a hook bolt into the holes you drilled and place the coping in the notch on the mini ramp, while lining up the bolts with the holes in the 2x4. Use the previously drilled holes to mark the coping. Once the 2x4 has been drilled, place the coping in the notch on the mini ramp. Drill a 3/8" hole in each marked location at a slight downward angle. ![]() Also mark two in the middle at 2'-4 apart. Mark the 2x4 about an 1 1/2" down from the top, 6" in from each end. Do not get towed by bicycles or motor vehicles.To attach the coping to the mini ramp with bolts, you will need to drill holes in the 2x4 behind where the coping will sit.Try to relax your body during a fall and try to roll instead of absorbing the force with your arms.While skateboarding, if you lose your balance, crouch down on the skateboard to reduce the height of the fall, and try to land on the fleshy parts of the body.Do stretching and conditioning exercises before and after skateboarding. Only skateboard when in good physical condition.Complicated tricks require practice in a specially designed area. Don’t skateboard faster than your experience allows or faster than the conditions permit.Make sure the skateboard is in good working order (no loose, broken or cracked parts, non-slip surface on board, no sharp edges).Wear slip resistant shoes with a closed toe. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |